Set of three plug and play harnesses for installing a supercharger on a '15-17 Mustang GT 5.0 L. Includes: IAT/MAF harness (connects to IAT2 sensor and in line with MAF sensor), Brass IAT sensor for lower manifold, EVAP Extension, Throttle Body extension...

VMP Performance 15-17 Ford Mustang 5.0L SC PnP Harness Kit - G style TB

This set of harnesses is used when installing a rear-inlet positive displacement blower on a 2011-2014 5.0 L Mustang or F-150. Fits Roush, VMP, and Whipple kits, will fit others with similar throttle body locations and kits that use the old style...

This set of harnesses is used when installing a rear-inlet positive displacement blower on a 2011-2014 5.0 L Mustang or F-150. Fits Roush, VMP, and Whipple kits, will fit others with similar throttle body locations and kits that use the old style...

VMP 11-14 Coyote IAT2 harness for supercharged 5.0 L. Used when installing a supercharger kit on a 11-14 Mustang or F150 Coyote engine with the factory processor. Allows you to measure Intake Air Temperature (IAT, also called ACT or MCT) through an...

A VMP exclusive. Plug and play (no soldering) harness to use 05+ MAF slot-style sensor on all 96-04 Ford Vehicles. No more buying a MAFIA just because you don't want to cut and solder on your harness. This harness mates to your existing 4-pin or 6-pin...

VMP 8 inchPNP harness extension for MAF or throttle body Direct plug and play adapter for stock or VMP throttle body. Made from high quality wiring made in the USA. This harness is used with all VMP Loki kits and 15+ Odin kits so the factory TB harness...

Are you interested in adding a VMP throttle body to your 2015-2017 Roushcharged Mustang or F150? This Y-Harness will allow you to seamlessly connect to the factory Roush wiring and connect to your new VMP Performance throttle body. Suitable for VMP...

MAF IAT breakout harness for connecting a GM style IAT sensor to be located in a positive displacement supercharger lower intake manifold. Used to properly measure air temp for IAT retard. Included with 15+ VMP supercharger kits. Required when using a...

Connector for 96+ IAT / ACT sensors. Includes 12 of wire. Can be used with threaded style sensor from Lightning/Cobra or push-in style sensors found on 96-00.To avoid potential problems this harness should be soldered. When hooking this harness up...

VMP Performance 15-17 Ford Mustang GT PNP Hellcat Throttle Body Jumper Harness

This is the IAT harness used in our Odin and Loki supercharger kits for '11-'14 Coyote powered Mustang. This inlet air temperature harness is also for use with PD blower (VMP, Whipple, and Kenne Bell) set-ups, that are not running a factory 11-14 Mustang...